Posts Tagged ‘Plug’

Mittwoch, 3. Juni 2015

Europäischen Stromsteckerkopf von Nikon MH-24 entfernen

Wer wie ich regelmässig in die USA fliegt, schätzt es, wo immer möglich US-Stromsteckerköpfe an Netzteilen einzusetzen. Das Akkuladegerät Nikon MH-24, welches ich mit meiner Nikon D3300 gekauft habe, vereint beide Welten. In der unmodizifierten Fassung verfügt das Ladegerät über einen us-amerikanischen Stromstecker.

Bei in Europa verkauften Kameras legt Nikon dann einen aufsteckbaren Adapter bei, welcher das Ladegerät mit dem zweipoligen, runden Europaanschluss mit unserem Kontinent kompatibel macht.

Tritt man eine Reise nach Nordamerika an, empfiehlt es sich deshalb, den europäischen Aufsteckknopf zu entfernen. Dies ist auf Anhieb gar nicht so einfach. Eine Google-Suche hat mich deshalb auf folgende Forumsdiskussion gelenkt:

First you need to find a small flat screwdriver, you will also need something narrow that will fit into a hole about 3-4mm across (keep it clean guys I found a biro nib was ideal, you’ll have to remove it from the pen casing first though.

Hold the charger with the pins facing away from you like you’re about to put it into a power-socket, slide the flat screwdriver into the gap between the top of the charger and the join between the plug adapter (you’ll notice that there is a small hole here, but its easier to use a screwdriver trust me), slide the screwdriver in as far as you can (just to the side of the hole, as the catch is about 4mm wide either side of the hole) and keep pressure on it. Turn the whole unit 90 degrees so that you’re looking at it sideways; now gently pull the 3 pin adapter from the bottom away from the charing unit, as if you are peeling it off like a sticker.

This should release the catch at the top, however, you still have the catch at the side to deal with, and not much room to manouvre, I managed to release the second catch by twisting the 3 pin adapter towards the catch, however, this could damage the plastic catch a little, so to play safe, use your narrow item to push in the catch….you’ll have to push very hard to release it though.

Quelle: MH-24 plug charger problem?

Obwohl der lange Text auf den ersten Blick hin abschreckt darf ich beruhigen: Es ist wirklich ganz einfach. Man nehme einen kleinen, flachen Schraubenzieher und stosse diesen in Folge unter die beiden Plastic-Klemmen, mit welchen der Europa-Stecker an das Netzteil angemacht ist. Der Adapter löst sich und gibt die US-Stecker frei.

Ich habe das Prozedere nun bereits viele Male durchgeführt, ohne dass das Netzteil oder der Adapter je Schaden genommen hätten.

Tags: , , , , , ,
Labels: Uncategorized

Keine Kommentare | neuen Kommentar verfassen